Tabla de contenido
Idiomas disponibles
Idiomas disponibles
UNPACKING AND CONTENTS
IMPORTANT:
Due to modern mass production techniques, it is unlikely the tool is
faulty or that a part is missing. If you find anything wrong, do not operate the tool until
the parts have been replaced or the fault has been rectified. Failure to do so could result
in serious personal injury.
CONTENTS IN PACKAGE
Description
Oscillating Tool
Bi-Metal Flush Cut Blade 1-3/8"
Segmented Saw Blade 3-1/8"
Coarse Tooth Flush Cut Blade 1-3/4"
Rigid Scraper Blade
ASSEMBLY AND ADJUSTMENTS
WARNING:
adjusting, installing accessories, or checking a function of the tool.
With the Accessory Quick-Change System on the tool and GeNeSIS™ universal Quick-Fit accessories included,
changing the accessories does not require an additional tool.
To Install the Accessories (FIG 2)
1. Flip the Accessory Quick-Change Lever (3) forward completely to separate the blade flange (a) and shaft
flange (b) as shown on FIG 2.
2. Slide the open-end of the accessory into the gap between the blade flange (a) and the shaft flange (b). The
shaft flange of this tool comes with a 6-pin design. Place the accessory over the pins on the shaft flange.
Make sure the holes on the accessory properly engage 5 of those 6 pins.
3. Flip the Accessory Quick-Change Lever (3) back to locked position to secure the accessory in place.
Q'ty
1
1
1
1
1
Always be sure that the tool is switched off and unplugged before
3
UNLOCKED
Description
Delta Hook & Loop Sanding Pad 1
Sandpapers
Storage Case
Operator's Manual
a
b
LOCKED
Q'ty
12
1
1
FIG 2
7
Tabla de contenido
