Technical Assistance - S&P SL-2500N A Manual De Instrucciones

INSTRUCTION FOR USE
• Model SL-2500N: Press the front button and hot air will be blown for 30 seconds; after
said time, the hand dryer will stop automatically.
• Model SL-2500N A: By placing hands underneath the air output, at a distance of ap-
proximately 10 cm, the movement sensor will automatically activate the hand dryer until the
hands are withdrawn.
After 1 minute of continued operation, the appliance is programmed to switch off automati-
cally, until its next use.
IMPORTANT: To meet different installation criteria, the sensitivity of the movement sensor has
been adjusted to the maximum on leaving the factory. If the appliance is operating continu-
ously or does not detect hands easily, the sensitivity will need to be adjusted according to the
following instructions.
ADJUSTING THE SENSITIVITY OF THE MOVEMENT SENSOR (MODEL SL-2500N A)
• (Figure 1) Remove the two screws located on the lower part of the appliance (5).
• (Figure 3) Without removing completely the metal cover, use a small screwdriver to access
the sensitivity regulator. If the appliance is operating continuously, reduce the sensitivity (-).
Otherwise, if the appliance does not easily detect the hands, increase the sensitivity (+).
MAINTENANCE
• Before carrying out any maintenance task, ensure that the appliance is fully disconnected
from the power supply.
• The hand dryers do not require continuous maintenance; just clean the exterior with a cold
damp cloth. Ensure that the air input grill remains completely free of dust.
• Do not use detergents or abrasive products.
DECOMMISSIONING / RECYCLING
EEC directives, and the commitment we have to future generations, bestow a
responsibility to recycle materials; all waste from packaging should be placed in
the corresponding recycle bins, and all appliances replaced should be taken to the
nearest Waste Services Centre.

TECHNICAL ASSISTANCE

The extensive Network of Approved S&P Dealers guarantees the appropriate technical as-
sistance.
If some anomaly in the operation of the appliance is detected, please contact any of the afore-
mentioned dealers, who will assist you as necessary.
9