Raider Pro RDP-YBD20 Solo Manual De Instrucciones página 24

24 www.raider.bg
done gradually, as periodically removed from the drill hole to remove chips or dust. If during drilling to drill
block up in holes, you should exclude drill. Use a change of direction of rotation to remove the drill from
the hole. Drill must be kept in alignment with the hole. Ideally, the drill should be placed perpendicular to
the surface of the material being processed. If the condition for perpendicularity is not respected at work
can lead to trapped or breakage in drill hole and injury to the user. Continued drilling at low speed the
engine from overheating threatens. Must make periodic breaks during work or to allow the drill to work on
no-load maximum speed for about 3 minutes. Do not obscure the openings in the hull used for ventilation
of the engine.
9.10. Make periodic breaks at work.
9.11. Keep and refer to the accessories carefully.
9.12. Do not throw the tool, do not overload, do not soak in water and other liquids do not use it for
mixing adhesives and concrete coatings.
10. Operation and maintenance.
Clean the body with dry cloth. Do not use any cleaning agents, as they may damage the casing.
10.1. Drill chuck replacement.
Quick-release chuck is screwed onto spindle of the drill and additionally secured with a screw.
Set the direction selector switch (2) in middle position.
Open chuck jaws.
Unscrew the fixing screw with cross screwdriver by turning it clockwise (left-hand thread).
Install hex key in the chuck.
Gently tap the second end of the hex key.
Unscrew the chuck.
Installation of the chuck is similar to installation, only the sequence of actions is reversed.
10.2. The cordless drill is equipped with a brushless motor.
Worn-out (shorter than 5 mm), up or broken engine carbon brushes should be replaced. Always
replace both brushes simultaneously. Work on replacement of carbon brushes entrusted only to qualified
person with original spare parts in RAIDER service.
10.3. All faults should be repaired by RAIDER service workshop.
10.4. The repair of your power is best carried out only by qualified specialists, which used only
original spare parts. This ensures their safety operation.
11. Environmental protection.
11.1.In order to protect the environment, the power tool and packaging must be suitably
processed for the re-use of the raw materials contained therein. Do not dispose of power
tools in household waste! According to the European Union Directive 2012/19 / EC on
end-of-life electrical and electronic devices and the validation and as a national law, power
tools that can no longer be used must be separately collected and subjected to
appropriate processing for the recovery of the contents raw materials.
11.2. Rechargeable battery.
Lithium-ion battery (Li-ion).
Do not dispose of batteries in household waste or in water tanks! Do not burn them!
Batteries should be collected, recycled or disposed of in an environmentally friendly way. According to
Directive 2006/66 / EC, faulty or waste batteries or batteries must be recycled.