Idiomas disponibles
Idiomas disponibles
3.10
Ice maker (if applicable)
Press the MENU button until the ice maker symbol lights up, then press the SELECT button to enable the
function.
When the ice maker is enabled, the ice maker operates automatically and ice cubes accumulate in the ice
tray.
NOTE: Prepare the water filter for use before using the ice. After connecting the refrigerator to a water
source or replacing the water filter, fill and discard two full containers of ice.
3.11
Water filter replacement (if applicable)
The water filter symbol flashes and beeps to advise you to replace the water filter.
When you are finished, press and hold the SELECT button for 5 seconds to reset.
The preset replacement time is 130 days.
3.12
Celsius and Fahrenheit selection
Press the MENU button until the Celsius and Fahrenheit selection symbol lights up to change between
Celsius and Fahrenheit. Press the SELECT button to confirm.
4.1 Things to do to save energy
A
•
Do not leave the doors of your refrigerator open for a long time.
•
Do not put hot food or drinks in your refrigerator.
•
Do not overload the refrigerator. Refrigeration performance will decrease if air circulation inside the
refrigerator is obstructed.
•
Do not place the refrigerator in direct sunlight.
•
Install the product at least 30 cm away from heat sources such as hobs, ovens, heater units, and
stoves and at least 5 cm away from electrical ovens.
•
Store your food in closed containers in the refrigerator.
•
You can remove the drawer shelf of the freezer compartment to fill the freezer compartment with the
maximum amount of food.
DISPLAY PANEL SETUP INSTRUCTIONS
BEFORE USING THE REFRIGERATOR
4.
Connecting your refrigerator to energy-saving systems
is dangerous, as they may cause damage to the product.
13
