Idiomas disponibles
Idiomas disponibles
FR
If incorrectly installed, the device may be dangerous and cause injury. Before any installation, check the
electrical network data. Plug in the device only when it complies. The device must be unpacked and checked
completely before connection by a professional.
5.2Use
WARNING
The installation of the device and maintenance should only be carried out by professionals.
• Do not leave the device running without monitoring it.
• During use, your hands must be dry.
• Do not move or tilt the device during operation.
MANUAL
FACILITY
Installation, adjustment and adaptation to other types of gas as well as commissioning can only be carried
out by an instructed person, authorized for this type of operation and only in accordance with the standards in
force. The appliance must be placed in a well-ventilated space to ensure the draft of combustion gases. The
device needs 2 m3 of air over 1 hour and 1kW of power.
The device can be installed alone or in series with other devices of our manufacture. It is necessary to
respect the
minimum distance of 10 cm between the device and other objects as well as avoid contact with flammable
materials. In this case, make the necessary arrangements to ensure protection of flammable parts.
Safety distances for flammable materials according to their degree of flammability:
-A non-flammable: granite, sandstone, concrete, bricks, ceramic tiles, coating
-B hardly flammable: acumin, heraclitus, lihnos, itaver
-C1 poorly flammable: wood from hardwood trees, plywood, hardened paper, umakart
-C2 medium flammability: chipboard, solodur, cork, rubber, coverings
-C3 easy flammability: wood fiber boards, polystyrene, polyurethene, PVC
Place the device upright on a solid, flat surface. This is equipped with adjustable feet.
FR
• EN 06 1008 fire protection for local energy consumers and heat emitters
• EN 33 2000 (33 2000-4-482; 33 2000-4-42) the environment for electrical appliances
Drawing of combustion gases
Type A device (see device label)
Type A devices (devices not connected to a chimney) must be installed in well-ventilated premises according
to current standards, to prevent the accumulation of substances that could harm health at dangerous
concentration levels.
Before the first start-up, remove the protective sheet. Clean all surfaces with a soft cloth, lukewarm water and
detergent to remove any anti-rust products applied during manufacturing, then wipe the unit dry with a clean
cloth. .
TO AVOID THE FORMATION OF RUST, THE SURFACE OF THE PLATES MUST BE TREATED
WITH VEGETABLE OIL AFTER EACH CLEANING
Turn on the appliance at full power for approximately 15-20 minutes to cook the plate.
Never leave the device running unattended!
Grease collector drawer
This container must be checked regularly and emptied in time. The container must be cleaned after each
unplugging of the appliance.
