Idiomas disponibles
Idiomas disponibles
• To install the battery pack, slide the battery pack (3) into
the bottom of the rear handle all the way until it locks
in place with a click, as shown in FIG 4. Lightly pull on
the battery to ensure it is locked into place and will not
accidentally fall out of the tool, causing an injury.
WARNING:
personal injuries, read and follow all important safety
warning and instructions before using this product.
WARNING:
product is switched off before insertion or removal of
the battery pack.
CHARGING THE BATTERY (FIG 5)
NOTE:
Always check that the power supply corresponds
to the voltage on the ratings plate.
• Plug the charger (9) into a 120 Volt AC power source.
The green indicator light on the charger will illuminate,
confirming it is powered.
• Connect the charger to the battery pack (3) as shown
in FIG 5. The red light on the charger will illuminate,
indicating that the battery is charging. Meanwhile, the
power indicator lights (3b) on the battery pack will flash,
indicating the charging status.
• All three indicator lights will turn solid green once
charging is complete.
• It is normal for the battery pack to become warm while
charging.
• If the battery pack is hot after continuous use in the
tool, allow it to cool down to room temperature before
charging. This will extend the life of your batteries.
NOTE:
It takes approximately 80 minutes to charge up
a completely discharged 2.0Ah battery pack.
3b
3c
3
BATTERY POWER INDICATOR (FIG 5)
There is a battery power indicator on the battery pack. It
has three green lights (3b). Depress the power indicator
button (3c) on the side to check the battery power level.
When all three lights illuminate, it indicates the battery is at
full power. The battery is at half full power when two lights
illuminate. When one light illuminates only, it indicates that
the battery is at low power level and requires immediate
charging.
ASSEMBLY AND ADJUSTMENTS
OPERATION
To reduce the risk of serious
Always be sure that the
9
FIG 5
• To remove the battery pack, pull the battery away from
the tool while depressing the battery locking tab (3a).
WARNING:
battery pack from the product or place the switch in the
locked or off position before any assembly, adjustments
or changing accessories.
HOLDING THE HEDGE TRIMMER
The trimmer has both front and rear handles. With the blade
directed away from you, hold the unit by both handles. The
switch in the front handle can be activated on any of the
three sides, giving you many choices for a comfortable grip
when performing cutting operations.
WARNING:
the hedge trimmer handles. Never hold shrubs with one
hand while operating the hedge trimmer with the other
hand. Failure to heed this warning may result in serious
injury.
STARTING AND STOPPING THE
TRIMMER
The hedge trimmer is equipped with two switches designed
to be used together to prevent accidental start-ups.
• Hold on to the front switch (2-FIG 1) & handle (4-FIG 1).
Depress the front switch and hold.
• Depress the rear trigger switch (1-FIG 1) to start the
hedge trimmer.
• The hedge trimmer will stop if you release either the
front or rear switch.
ENGLISH
Always disconnect the
Always keep both hands on
7
