2N IP ONE Manual Del Usuario página 3

IN1
12 V / 2 A
LAN
Main Unit Backside Button Description
Button
1
2
Security
The 12V output is used for lock connection. If the device is installed in a location where
there is a danger of unauthorized tampering, the use of a 2N Security Relay (Part No.
9159010) is strongly recommended. Device that is installed between an intercom (outside
the secured area) and the electric lock (inside the secured area). 2N Security Relay
includes a relay that can only be activated if the valid opening code is received from the
intercom.
Configuration
Configure 2N IP One using your PC with any internet browser:
Launch your Internet browser (Chrome, Firefox, etc.).
Enter the IP address of your intercom (http://192.168.1.100/, e.g.).
Log in using the username Admin and password 2n.
IP Address Retrieval
To retrieve the IP address, press the Speed dial button 5 times.
To retrieve the device IP address you can also use 2N Network Scanner, which can be freely
downloaded from www.2n.com.
Static IP Address Setting
To set the Static IP address mode (DHCP OFF), press the Speed dial button 15 times.
Dynamic IP Address Setting
To set the Dynamic IP address mode (DHCP ON), press the Speed dial button 15 times.
Factory Reset
• The CONTROL button is used for resetting the default factory values.
Follow the instructions below to reset the factory default values:
• Disconnect the device from the power supply.
• Press and hold the CONTROL button.
• Connect the device to the power supply.
• Keep holding the button for a few seconds and then release it.
Device Restart
To restart the device, disconnect the device from the power supply or use the web interface
in the System / Maintenance section. No configuration change appears after the restart.
IN1 terminals for input in passive/ active mode
(−30 V to +30 V DC)
• ON = closed contact or UIN < 1.5 V
• OFF = open contact or UIN > 1.5 V
Terminals for external 12V / 2 A DC power supply
LAN (PoE according to 802.3af) connector
Button name
Tamper Switch
CONTROL button
Function
The purpose of the tamper switch is to signal
any unauthorized opening of the intercom (to
prevent a theft, e.g.).
Used for resetting the default factory values.
5
2