AFIRE Design ADVANCE Serie Instalación Uso Y Mantenimiento página 17

The ON/OFF button turns the device on and off. Button B1 is used to fill the reservoir with water. Button
B2 is used to empty the device. Hold the button for 5 seconds to start the pumps. Press once to stop the
The stainless-steel "Tube" connection connects to the plastic
AWA without draining button.
pumps.
hose provided to fill and empty the device.
ATTENTION: The water used must be perfectly clean with no dust or reside that may clog the
hydraulic system. This point is very important for the operation of your device.
B. Using your device for the first time
Depending on your type of device (AWPR), it may be connected directly to your home's water network (see
diagram below, ¼" ). In this case, if you press the ON/OFF button and the isoalation tap on the hydraulic
circuit is open, the device will fill automatically. In all cases, if you do not use your device, shut off the
income water supply to avoid leaking.
If the device is not connected to the water network, you can fill the reservoir using button B1 (fill). To do so,
first, connect the provided hose to the stainless-steel connector (tube) and submerge the mart of the hose
with its filter in a container of water. Then, press the ON/OFF button. The row of orange LEDs will blink
immediately (empty reservoir). Then, press B1 during 5 seconds once and the filling pump will start and
stop automatically when the reservoir is full. The orange LEDs will remain on and vapor will start to come out
of your device. Note: for the first filling, you will need: 2 liters for AWA20-50 and AWPR20-50, 4 liters for
AWA40-100, AWPR40-100, 6.5 liters for AWA60-150 and AWPR60-150. Then, you can control your device
using the remote control or the App.If your device is an ADVANCE AWA, use Button B1 to fill water.
C. Caution
Tap water may be used in our devices, however, be sure the water is not considered to be "hard" and
that it contains no impurities (may clog valves). If your water is hard, you must use filtered or softened
water in order not to wear out the Mist Maker too quickly.
¼"
Direct connection to the water network
www.a-fireplace.com 16