Installation Diagrams - AFIRE Design ADVANCE Serie Instalación Uso Y Mantenimiento

5. Installation diagrams

AFIRE devices are meant to be embedded without needing any ventilation in the housing for the device.
obstruct the air inlets located on the top of the device.
In the housing, you must install a normal 110/240 volt (12 amp) electric current in order to power the device
through a 24-volt transformer.
You must also install water supply if you want to connect your device directly.
tap outside the recess in order to be able to close the water supply if necessary (drainage, etc.)
See the diagram below for the embedding dimensions.
You must leave 5 cm minimum around the device to facilitate installation.
Do not obstruct the air inlets located on the top of the device.
Embedding dimensions
www.a-fireplace.com
This water arrival must include a
Do not
14