Idiomas disponibles
Idiomas disponibles
Optional step: Initiate the lock function
Long press the "▲" up button of the receiver for two seconds to lock your settings and to
avoid accidental touch.
*NOTE:
For PWR-6000, press the " ▲ " up and " ▼ " down buttons to select the desired channel first.
The selected channel will flash, and please press SET to confirm. Then follow the step above.
2s
Multiple system setup
You are suggested to use no more than 16 transmitters simultaneously（band and RF environm-
ent depend).
*NOTE:
For efficient multiple system setup, set up each system one-at-a-time and initiate the auto-scan
function to intelligently find optimal frequencies to operate. Leave a receiver and tuned transmitters
powered on so that other receivers can detect that those channels have been occupied.Turn on any
other equipment that could cause interference during the performance which can be detected by the
receiver's auto scan function to avoid multiset interference in the following steps.
Before you begin the system setup, turn all receivers ON and all transmitters OFF.
① Initiate the auto-scan function for a channel of a receiver.
② Turn on the first transmitter and pair it up with the receiver.
③ Repeat the above two steps until set up all channels.
④ Leave transmitters on and continue with additional systems according to the above three steps.
⑤ Once all systems are set up, make sound check on all transmitters.
▲
G.
CH
SET
MHz
▼
▲
SET
▼
PWR-6000
Select the channel first, and then lock your settings.
®
▲
G.
CH
SET
▼
"L ON" for locking in,
and "L OF" for locking off
*NOTE
IR
▲
SET
▼
8
