Idiomas disponibles
Idiomas disponibles
OPERATION INSTRUCTIONS
1 • Place the unit on a flat surface and in a suitably large area with at least 50 cm of
open space around the unit.
2 • Open the top lid of the water tank.
3 • Fill the water tank with distilled water.
4 • Fill the fluid tank with fog fluid.
5 • Plug the power cord into the outlet and turn on the unit, put the power switch to
the "ON" position. The LCD display will show "WARMING UP". After few seconds
the LCD display will shows "READY".
6 • Using the LCD display panel, set the unit to the desired operating mode.
7 • Turn off the unit, put the power switch to the "OFF" position and pull out the
power cord from the outlet.
6 • Before transporting the unit, empty water tank by connecting a tube to
drainage valves.
Use the 2 nylon hose
clamps included
When displays shows "READY", you can start producing haze and adjust the settings via LCD display panel.
Adjust the manual volume output within the range of 0% to
Man Vol Out xxx %
100% by means of the Up/Down keys
Adjust the interval between each fog emission within the range
Interval Set xxxS
of 1 to 100S by means of the Up-/Down keys
Adjust the duration of each fog emission within the range of
Duration Set xxxS
1 to 100S
Adjust the volume output during the timer function within
Volume Out xxx%
the range of 0-100%
DMX512 #xxx
Adjust the DMX address for DMX control
Adjust the wind output during the function within the range
Wind For Class xx
0-100% by means of the Up/Down keys.
Remote Out xxx% NO FUNCTION for this model.
P.15
!
DISCONNECT POWER
BEFORE ADDING LIQUID.
DO NOT OPERATE WITHOUT
LIQUID.
PLEASE USE ALGAM
LIGHTING FLUID ONLY.
Maximum water level
