Idiomas disponibles
Idiomas disponibles
GENERAL
The description below corresponds to the image on page 2:
1. Housing
2. Exhaust grille
3. Casters
4. Control panel
5. Water reservoir
BEFORE FIRST USE
1. Remove the packaging and all packaging materials.
2. Clean the device to remove any manufacturing residues. See 'Cleaning and maintenance'.
3. Press the castors (3) into the recesses at the bottom of the device.
4. Fill the cooling elements (6) with tap water up to the MAX indication and place them in the freezer for
24 hours.
REMOTE CONTROL
This device comes with a remote control that allows you to operate all functions.
VENTILATE
1. Use a jug or bottle to fill the water reservoir (5) with cold tap water. Maximum 3.3 litres.
2. Lock the water tank with the lock (8).
3. Plug it into the socket. A short signal sounds and the red POWER light comes on.
4. Switch on by pressing ON/OFF. The device always starts at low speed (Low speed).
5. Press ON/OFF again to stop ventilation.
COOLING
When cooling, use the 2 supplied cooling elements. Fill the cooling elements with tap water up to the MAX
indication and place them in the freezer for 24 hours. We recommend that you always place the cooling
elements in the freezer ready for use.
1. Place the frozen cooling elements in the water reservoir. Then fill the reservoir with as cold water as
possible. Please note: Not less than the MIN indication and not more than the MAX indication.
2. Lock the water tank with the lock.
3. Plug it into the socket. A short signal sounds and the red POWER light comes on.
4. Switch on by pressing ON/OFF.
5. Press COOLER to switch on the cooling function.
6. Press COOLER again to stop cooling.
The device will pump up the cool water and let it flow down through a filter. The fan blows the air stream
out through the cooled filter. The excess water is collected again in the water reservoir.
Attention:
•
The device stops cooling if there is too little water in the water tank. The light will flash and a signal will
sound when COOLER is pressed.
•
Change the water in the water reservoir at least once a week to prevent any bacterial growth.
VARY SPEED
Press SPEED repeatedly during use to switch between 3 speeds:
1. Low speed
2. Middle speed
3. High speed
6. Cooling elements (2x)
7. Airflow height adjustment
8. Locking
9. Water level indication
17
EN
