Oehlbach SCOPE VISION OUTDOOR Manual Del Usuario página 6

INSTALLATION
Internal/external wall mounting (Fig. 1)
Step 1. Mark the mounting position with a pen or pencil (use the mounting bar for this purpose).
Step 2. Use the supplied screws to screw the mounting bar to the wall.
You may need to use wall plugs depending on the wall. Use a 6 mm drill bit to drill a hole
approx. 35 mm deep.
Step 3. Secure the antenna to the mounting bar.
Step 4. Connect the antenna cable to the antenna and then run the cable to your set-top box or TV.
Step 5. Proceed as described in the section entitled "INITIAL OPERATION".
Mounting the mast (Fig. 2)
Step 1. Secure the mounting bar to a suitable mast by using the threaded brackets and wing nuts.
Step 2. Secure the antenna to the mounting bar.
Step 3. Connect the antenna cable to the antenna and then run the cable to your set-top box or TV.
Step 4. Proceed as described in the section entitled "INITIAL OPERATION".
10
INITIAL OPERATION
The antenna can be supplied with power in two different ways
Variant 1: Operating the antenna via an STB or digital TV (Fig. 3)
Fig. 3 Operation via STB or digital TV
STB or digital TV
Coaxial cable
1. Secure the antenna in place as described in the mounting section.
2. Connect the IEC connector of the supplied antenna cable to a set-top box or TV.
3. Connect the F-connector of the antenna cable to the antenna itself. The antenna cable can be
shortened to the required length and reattached with the supplied F-connector.
4. Align the antenna to achieve the best signal/image quality.
Variant 2: Operating the antenna via a power supply unit (this method is necessary if your set-top box
or TV does not have a DC output) (Fig. 4)
Fig. 4 Operation via power supply unit
AC adapter (DC 6V)
STB or digital TV
DC IN
Coaxial cable
1. Follow the steps specified for Variant 1 above, but connect the supplied amplifier between the
antenna cable and your set-top box or TV. When doing this, connect the antenna cable to the
"Antenna" input on the amplifier.
2. Then connect the output of the amplifier to the antenna input on your set-top box or TV.
3. Now connect the amplifier to the supplied power supply unit.
Scope Vision Outdoor
Indoor Outdoor
Water-drop loop
(recommended)
Indoor Outdoor
Coaxial cable Water-drop loop
(recommended)
11