Idiomas disponibles
Idiomas disponibles
TO REMOVE SAW FROM STAND
Figure 6
1. Raise the locking levers to
unlock the saw and tool mounts.
2. Lift away from the rear rail of
the stand to disengage.
3. With the assembly tilted
slightly toward you, lift the
assembly to disengage from the
front rail of the stand.
USING THE EXTENSION RAILS
Use the extension rails when working with larger work pieces.
TO EXTEND THE RAILS
1. Loosen the extension adjustment knob.
2. Extend the rail to the desired position.
3. Tighten the extension adjustment knob.
14
USING THE WORK STOPS
Raise the work stops whenever you need to make repetitive cuts
of the same size. To avoid a greater risk of binding or pinching, do
not use both work stops at the same time.
TO RAISE THE WORK STOPS
1. Loosen the work stop adjustment knob.
2. Raise the work stop to the desired position.
3. Tighten the work stop adjustment knob.
USING THE MATERIAL SUPPORT PEGS
1. Fold down the support pegs located on each front leg.
2. Use to hold/store 2x4 or other long cut pieces off the ground.
TRANSPORTING AND STORING
Figure 7
1. Before storing or transporting, make sure all attachments are
secure and benchtop tool is removed. Collapse extension rails.
2. To fold front legs, lift up on one end of the Work Stand with
handle and depress the leg-lock lever. Pivot collapsing legs until
the lock pin engages to hold the leg in the closed position.
3. Work Stand can be transported by grasping the handle with
one hand and material support with other hand for balance. Roll
like a wheelbarrow.
15
