Costway TJ10008 Manual Del Usuario página 6

ATTACHING THE PULL HANDLE
Figure 2.
1. Place (2) M6 bolts through the holes in the handle.
2. Place the handle onto the end of the miter saw stand and make
sure the M6 bolts pass through holes in the body.
3. Tighten M6 nut until secure.
ASSEMBLING THE WORK SUPPORT AND WHEEL
Figure 3
1. Slide the work support mounting bracket over the extension
rail.
10
Bolt M6x30
Nut M6
Handle
2. Tighten Lock Bolt M8 until secure.
3. Place the wheel axle onto the end of the miter saw stand.
4. Place a washer φ12, wheel, washer φ8, nut M8 over each side
of the wheel axle.
5. Tighten nut M8 over the washer until secure.
6. Fix the fixing plate on the table surface with M6 nuts.
Work Support-B
Work Support
Mounting Bracket
Lock Bolt M8
Wheel
Washer φ8
Nut M8
ATTACHING YOUR MITER SAW OR OTHER
BENCHTOP POWER TOOL
Figure 4
Various bench top tools can be used with your Rolling Miter Saw
Stand by attaching them to the Rapid Clamp Tool Mounts. Always
position the saw to achieve maximum balance and stability.
Work Support-A
Work Support
Mounting Bracket
Lock
Bolt M8
Stator
Bolt M6x30
Washer φ12
11