Idiomas disponibles
Idiomas disponibles
INSTALLATION
1.
Ensure no object is placed within 400mm of the induction sensor. Do not install the hand dryer in direct
sunlight. Do not install the hand dryer near flammable gas or objects.
2.
Hold the stainless steel plate against a flat, smooth wall in the desired position and mark the holes.
3.
Drill the marked holes approximately 35mm deep and insert the wall plugs.
4.
Fix the stainless steel plate to the wall using the screws provided.
5.
Hang the hand dryer on the stainless steel plate.
MAINTENANCE
•
The exterior cover of the hand dryer should only be cleaned using a damp cloth. Do not use chemicals,
solvents or abrasive cleaners. Please switch off or disconnect power supply before cleaning.
•
To avoid the risk of electric shocks and damages to the product, ensure there is no leaking/excess water
dripping onto the hand dryer.
•
Disconnect all power prior to installation and before carrying out any service to the hand dryer.
•
For long periods of no usage, ensure the power supply is disconnected.
ELECTRICAL DIAGRAM
CONFORMITY
Conforms with relevant European Directives
ENVIRONMENTAL PROTECTION
For electrical products sold within the European Community.
This appliance is labelled in accordance with European Directive 2002/96/EC concerning
Waste Electrical and Electronic Equipment (WEEE). Waste electrical products should not be
disposed of with household waste. Please recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
Motor
Control PCB
www.firedupcorporation.com
AC110~240V
Air circuit breaker
Fired Up Corporation Ltd
Fired Up Buildings
HD1 3LF, UK
Fired Up Corporation
(Ireland) Ltd
71, D02 P593, Dublin
