Idiomas disponibles
Idiomas disponibles
3.
Press the
4.
Press the
5.
Press the
6.
Press and hold the
value will increase by 100 each time. When the
repeat the above steps. Note: The setting parameter cannot exceed the user-defined limit (see
table below), or else it will return to the initial value to start the loop.
7.
Press and hold the
Set the power to enter the power saving mode (PSI):
1.
In the parameters setting interface, press the
2.
Press and hold the
3.
Press the
4.
Press the
5.
Press the
or
button to set the PSO parameter.
button to decrease the PSO value by 1.
button to increase the PSO value by 1.
button to increase the PSO value by 10. After adding ten times, the PSO
button to confirm.
button until the PSI value flashes.
or
button to set the PSI parameter.
button to decrease the PSI value by 1.
button to increase the PSI value by 1.
button is released, press and hold it again to
or
button to select the PSI parameter.
