Idiomas disponibles
Idiomas disponibles
EN
flange once it has been seated or the seal
may be broken.
5. Place a heavy object, such as the disposer
(use a towel to prevent sink scratching) on
top of the sink flange to hold it down.
6. Take the remaining portion of the mounting
assembly, that was put aside. From under
the sink insert the flat gasket (3), then the
support flange (4), and then the upper
mounting ring (5).
7. Hold the three parts in place while attaching
the retainer ring (6) by pulling it apart and
sliding it onto the sink flange (7) until it snaps
into the groove of the sink flange (7).
3
4
5
8. Tighten the three mounting screws evenly
and firmly against the supporting flange (8).
Do not over tighten.
9. Trim off any excess plumber's putty.
10. Attach disposer onto the upper mounting
ring by aligning the three mounting tabs on
the lower mounting ring with the slide-up
ramps on the upper mounting ring and
rotating counter clockwise.
B
FWDS50 / FWDS75 / FWDS75BF / FWDS100 / FWDS125
1
6
7
A
C
11. The lower mounting ring (which is part of the
disposer) has 3 tabs that grab the mounting
ring ramp.
(A) points to the upper mounting ring.
(B) is the tab that slides up onto the "Ramp".
(C) is the „Ear" that is used to help rotate the
lower mounting ring.
2
Use a screwdriver for leverage if needed.
12. Lift and turn the lower mounting ring counter
clockwise until all three mounting tabs lock
over the ridges (F) on the slide-up ramps (D)
of the upper mounting ring.
8
13. As the lower mounting ring is turned counter
clockwise each tab slides up onto the upper
mounting ring ramp (E) and locks in position
over the ridges (F).
Use a screwdriver or hammer for leverage if
needed.
If a disposer needs to be removed, tapping on
the Ear clockwise with a hammer will easily
loosen the lower mounting ring.
Electrical connection
Connect disposer to appropriate
household current only.
This appliance must be controlled by an
external on/off switch.
Warning: Improper connection of the
equipment-grounding conductor can result in a
risk of electric shock. Check with a qualified
electrician or serviceman if you are in doubt as
10
D
F
E
