Idiomas disponibles
Idiomas disponibles
MONZA
If required to operate the multiple fans with multiple remote control individually, then the remote /receiver
need be paired. or if the remote and receiver lose control after installation or during use, the pairing of the
remote and the receiver must be repaired.
When operating this pairing function, please stand within 3 meters distance to the fan.
PAIRING REMOTE & RECEIVER – WHEN 1 DC CEILING FAN IS INSTALLED IN ONE LOCATION
NOTE: Ensure that you have installed a single pole disconnection switch in the fixed wiring for the fan.
NOTE: Ensure power to the receiver is ON prior to pairing the remote with the receiver.
•
Turn OFF the mains supply to the fan by on/off wall switch.
•
Install the battery into the remote. Please make sure the polarity of the battery is correct.
•
Turn ON the power to the receiver.
•
Press and hold the "
ON to the receiver of the ceiling fan. the green LED at top of the remote will flash two seconds to indicate
the paring process is activated.
•
Turn ON the fan and change the speed of the ceiling fan via the remote to check the operation and
successful paring.
•
If pairing has been unsuccessful, repeat these set of steps again.
PAIRING REMOTE & RECEIVER – WHEN 2 OR MORE DC CEILING FANS ARE INSTALLED IN ONE
LOCATION
NOTE: Ensure that you have installed a single pole disconnection switch in the fixed wiring for each fan.
If you want to control 2 or more ceiling fans with one remote, do as explained in the normal pairing
⚫
process, but make sure all ceiling fans wall switches are turned ON.
If you want to control them with individual remotes, do as explained in the normal pairing process, but
⚫
make sure the other ceiling fans wall switches are turned OFF. After the first fan is paired turn the wall
switch OFF and continue the normal pairing process with the next fan.
RESET TO DEFAULT:
within 1 minute after the fan is powered on, press the "0" button for 15 seconds. When it exceeds 5 seconds,
the green LED at top of remote be a flashing two seconds for pairing. Keep holding down the button until
exceeds 15 seconds, the green LED flash again two seconds again, Receiver will return to the default factory
setting.
Note: when operating this reset function, please stand within 3 meters distance to the fan.
RESET OF WIFI MODULE (WIFI MODULE SOLD SEPERATLY) :
Press the "
" button & the "
at top of remote will flash for two seconds .
Note: when operating this reset function, please stand within 3 meters distance to the fan.
54 | Page
" button on the remote for 5 seconds within 60 seconds of switching the power
" button on the remote simultaneously for 15 seconds, the green LED
