Idiomas disponibles
Idiomas disponibles
06. Safety Instruction
Watch your hands.
Take care of your belongings.
Keep treadmill upright and put it in a space
with supporting points on both sides. Please
keep away from children.
Do not fold before power off.
Do not get on and off
when the treadmill
operating.
07. Maintenance and Adjustments
1. Clean the treadmill
• Disconnect all sources of power before cleaning the treadmill.
• Add a small quantity of mild cleaner to a 100% cotton cloth. Do not spray the cleaner directly on
the walking belt or use acidic and corrosive cleaner.
• Do not wipe under the walking belt.
• After a period of exercise, dust and stains may appear on the rear floor. This is normal and can be
simply wiped.
2. Walking belt deviating
• If the walking belt is not centered:
lift the rear walking board and adjust the walking belt manually (refer to Page 7 "Set-Up Guide"
slipping and correction
Part).
• If the walking belt still deviates, adjust it with the Allen Key supplied by the following steps:
Walking belt goes to the left: turn the left adjusting hole screw clockwise by 1/4 turn.
Walking belt goes to the right: turn the right adjusting hole screw clockwise by 1/4 turn.
Walking belt is slipping: turn the left and right adjusting screws clockwise for 1/2 turn at the same
time. After each adjustment, run the appliance at a speed of 3-4 km/h (1.95-2.5 mph) for 1-2
minutes to observe the calibration. If necessary, adjust again.
* If the walking belt is too tight or too loose, it will affect the performance of equipment and damage
the walking belt.
3. Walking belt lubrication
• Power off the treadmill and unplug the power cord.
• Lift the edge of the walking belt and smear the inner surface with silicone oil.
• Start the treadmill to run at a speed of 3 km/h (2 mi/h) for 10-20 seconds.
• 5-10 ml of silicone oil is required for each lubrication. Excessive silicone oil may cause slipping
and affect normal use.
• Lubricate the walking belt every three months.
