Tabla de contenido
Idiomas disponibles
Idiomas disponibles
USE OF CALLUS REMOVER
This callus remover is designed to soften the thick skin of
the soles and heels, refrain from use in other parts of the
body.
1. For best results we recommend washing and drying your
feet. Remember that you can not use this appliance on
irritated areas with wounds, etc.
2. Remove the protective housing 1 and check that the roller
2 is properly engaged.
3. Press and hold the safety button 5, while moving the
switch / speed selector 6 forward.
The switch has two positions 1 and 2, corresponding to
normal and high speed respectively.
4. Support roll gently on the skin area to be treated, and
move forward and backward hardness remover for about
3 seconds (do not put excessive pressure on the skin).
5. Check the result, if not to your liking or you have not
obtained the desired softness, repeat step 4 to obtain the
desired result. If the machine has to pass pain, stinging or
irritation, leave the area to treat.
6. Once finished removing hardness, slide back the switch /
speed selector 6.
7. To remove the remains of dead foot skin, use a slightly
damp towel.
8. Before storing the hardness remover it is recommended
to clean it (see Cleaning section) and then place the
protective housing 1.
ABRASIVE ROLLER REPLACEMENT
The service life of the grinding roller, varies depending on
the use and the type or hardness of skin to be treated, the
abrasive roller must be replaced when you notice that the
abrasive grain is worn and it does not remove the dead skin.
6
Tabla de contenido
