Munchkin Extending XL Gate MK0004 Manual Del Usuario página 6

How To Install
5a. For Drywall Without Stud / Plasterboard:
Drill a 7/32"(5.5mm) hole into the drywall at each
pencil mark. Insert a drywall anchor into each hole.
Then, use a screwdriver or drill to insert the screws
through the upper and lower hinge wall bracket into
the drywall anchors.
Medium Drywall
screw anchor
Medium Drywall
screw anchor
5b. For Drywall with Stud:
Drill a 5/64"(2mm) pilot hole into the stud at each
pencil mark (no anchor needed). Then, use a
screwdriver or drill to insert the screws through the
upper and lower hinge wall bracket into the stud.
Medium
screw
Medium
screw
10
STEP 4: INSTALL LOWER CATCH (WALL BRACKET)
1. Place template "I" against
5a. Drywall
7/32"
5.5mm
2. Identify which lower catch
5a. Plasterboard
7/32"
5.5mm
5b. Stud
5/64"
2.0mm
the wall with tape, flush to
the floor. Mark the screw
Temp. I
holes with a pencil to create
(Catch Side)
indentation, then remove
the template.
wall bracket to use:
For Top and bottom of stairs:
Choose the 1 way lower
Open edge
catch wall bracket. The
opening on the edge of the
bracket should always be
facing towards you (away
from the stairs), so the gate
only swings away from
the stairs.
1 Way Lower Catch
Wall Bracket
For Hallway and Doorways:
Choose the 2 way lower
catch wall bracket so that
the gate swings in either
direction.
2 Way Lower Catch
Wall Bracket
How To Install
11