Tabla de contenido
Idiomas disponibles
Idiomas disponibles
The machines are prepared to work with an electric generator. However, these generators must meet certain require-
ments. It is recommended to use three-phase generators with a constant power of at least 25KVA. If the generator
does not have enough power or the output voltage is outside the operating limits of the machine, the stability of the
welding arc and, therefore, the quality of the weld joint could be affected. In the worst case, it can even cause da-
mage to the machine.
Do not use more than one welding machine with the same generator at the same time. Sudden changes in charge
level may affect the stability of the welding arc.
5 - Start the machine by turning the switch placed on the back of the power unit. During the startup sequence, the
machine performs an internal test. If a fault is detected, the associated code will appear on the front panel display.
Always start or stop the machine using the rear switch, NOT by plugging or unplugging it from the mains.
FRONT PANEL LAYOUT
1- Display
2- Amps visualization
3- Frequency
4- Voltaje or mm visualization
5- Percentage (%)
6- Time (0,1s)
7- Overtemperature
8- Common problems
9- Pre gas time
10- Starting current / time
11- Slope up time
12- Hot Start current in MMA
13- Nominal current
14- I force current in MMA
- I1 TIG pulsation current
15- I2 TIG pulsation current
16- Slope down time
SOLTER
SOLDADURA S.L.
Do not stop the machine while
1
12
13
11
10
9
20
22
MMA
23
31
30
32
33
17- Amps / time of stop
18- Gas Test
19- Post-gas Time
20- I1 TIG pulsation current time
21- I2 TIG pulsation current time
22- MMA welding selector
23- MMA mode
24- TIG DC mode
25- TIG welding selector
26- Menu Selector
27- Cooler activated
28- Power output activated
29- VRD (Voltage reduction device)
feature activated.
30- TIG pulsation current selector
31- TIG constant current mode
32- Low frequency pulse mode
in TIG
ATTENTION
welding.
2
3
4
V/mm
14
18
15
FORCE
16
17
19
21
24
TIG DC
37
34
36
35
AEROTIG DC
5
7
%
s.
6
8
26
MENU
27
OPERATION
28
29
PROGRAM
25
LOAD
40
41
SAVE
38
39
33- High frequency pulse mode
in TIG
34- Main Selector
35- HF ignition in TIG mode
36- 4T operation mode (in TIG mode)
37- 2T operation mode (in TIG mode)
38- Operation mode selector in TIG
39- Program visualitzation
40- Load a program
41- Save a program.
28
Tabla de contenido
