Idiomas disponibles
Idiomas disponibles
Installing Your Freezer
Unpacking Your Freezer
1. Remove all packaging material. This includes the foam base and all
adhesive tape holding the freezer accessories inside and outside.
2. Inspect and remove any remains of packing, tape or printed
materials before powering on the freezer.
Adjusting Your Freezer
Your freezer is designed for freestanding installation only. It should
•
not be recessed or built-in.
Place the freezer on a floor strong enough to support it full loaded.
•
When moving the freezer, never tilt it more than a 45-degree
•
angle.This could damage the compressor and the sealed system.
If the freezer is tilted, let it stand in an upright position for at least
•
24hours prior to plugging. This is to allow the refrigerant to settle.
Proper Air Circulation
To assure your freezer works at the maximum efficiency it was
designed for, you should install it in a location where there is proper
air circulation, plumbing and electrical connections. The following are
recommended clearances around the freezer:
Sides..........4"(102mm)
Back.....4" (102mm)
Top.........Do not block
WARNING: ELECTRICAL REQUIREMENT-SHOCK HAZARD
08
Electrical Requirement
Make sure there is a suitable power Outlet with proper grounding to
power the freezer.
Avoid the use of three plug adapters or cutting off the third grounding,
in order to accommodate a two plug outlet. This is a dangerous
practice since it provides no effective grounding for the freezer and
may result in shock hazard.
Install Limitations
Do not install your freezer in any location not properly insulated or
•
heated e.g. garage etc. Your freezer was not designed to operate in
temperature settings below 55°F/ 13°C ahrenheit.
Select a suitable location for the freezer on a hard even surface
•
away from direct sunlight or heat source e.g. radiators, baseboard
heaters,cooking appliances etc.Any floor unevenness should be
corrected.
Disposal
This appliance may not be treated as regular household waste. It
•
should be taken to the appropriate waste collection point for recycling
of electrical components. For information on local waste collection
points, contact your local waste removal agency or government office.
Disposal of this appliance should be in accordance with local
•
regulations.
09
