Idiomas disponibles
Idiomas disponibles
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome if its
use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off and
when it is running idle but not actually doing the job. This
may significantly reduce the exposure level over the total
working period.
Helping to minimise your vibration and noise exposure
risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
4. OPERATING
INSTRUCTIONS
12
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The machine is intended for sawing wood, plastic,
metal and building materials while resting firmly on
the workpiece. It is suitable for straight cuts.
ASSEMBLY AND OPERATION
ACTION
Tool-Free blade change
Installing/ Removing
removeable branch holder
Charging The Battery Pack
Installing/ Removing The Battery
Pack
20V Cordless Brushless Compact
Reciprocating Saw
On/Off Operation
1. Your saw is equipped with a
trigger lock switch. Press the
lock-off button to unlock the
trigger switch. (See Fig. D)
NOTE:Always lock the trigger
switch when carrying or storing
the machine.
2. Press the ON/OFF trigger
switch to operate. The deeper
you press the ON/OFF trigger
switch, the faster the machine's
speed. (See Fig. E)
3. LED light will illuminate the
working zone automatically
when the product is switched
on. (See Fig. F)
Footplate Adjustment
NOTE: Adjust the position of
footplate according to the blade
length and workpiece thickness;
always ensure that the blade
extends beyond the workpiece
throughout the stroke.
WORKING CONDITIONS
Branch Cutting
(Use wood cutting blade)
Use the metal cutting blade to
cut the following materials:
Pipe cutting
Metal cutting
Aluminum cutting
Use the wood cutting blade to
cut the following materials:
Wood cutting
PVC Cutting (Use wood cutting
blade)
NOTE: The max diameter of
PVC should be no more than
FIGURE
5 cm.
See Fig. A
See Fig.B
WORKING HINTS FOR YOUR
CORDLESS RECIPROCATING
See Fig. C1
SAW
See Fig. C2
If your power tool becomes too hot, set the speed to
maximum and run a no load for 2-3 minutes to cool
the motor.
Always ensure the work-piece is firmly held or
clamped to prevent movement.
The blade guard must be held firmly against the
material being cut to reduce saw vibration, blade
jumping and blade breakage.
See Fig. D, E, F
See Fig. G
See Fig. H
See Fig. I-K
See Fig. L
See Fig. M
EN
