Idiomas disponibles
Idiomas disponibles
9. Stop the engine.
10. Do a check of the hydraulic oil level and fill
hydraulic oil if it is necessary.
11. If it is necessary, do the above steps again until
all air has been removed from the hydrostatic
system. When the product operates correctly,
all air has been removed from the hydrostatic
system.
To do maintenance on the
hydrostatic transmission
CAUTION:
are to do warranty repairs must have
an approval before maintenance of
a hydrostatic transmission, unless the
servicing dealer is a current approved
servicing center for the brand of
transmission being serviced.
•
Do a check of the oil level in the expansion
tanks. If the engine is cold, make sure that the
tanks are at the FULL COLD level.
•
Examine the drive belt, idler pulleys and idler
springs. Make sure that the drive belt has traction
and that the tension is correct.
•
Examine the transmission cooling fan for broken
and bent blades.
•
Remove grass, leaves and dirt.
•
Examine the parking brake and vehicle linkage to
make sure that they operate correctly.
•
Examine the vehicle control linkage to the
directional control arm on the transaxle.
•
Make sure that the control arm is correctly
attached to the trunnion arm of the transaxle.
•
Examine the bypass mechanism on the transaxle
unit linkage to make sure that it rotates and
releases fully.
Lubrication, general information
•
Remove the ignition key to prevent accidental
movements during lubrication.
•
Clean the area before you lubricate a part on the
product.
•
Use oil when you lubricate with an oil can.
•
When you lubricate with grease, use a chassis
or ball bearing grease that prevents corrosion.
Remove unwanted grease after lubrication.
•
Lubricate 2 times a week if you operate the
product daily.
•
Do not spill lubricant on the drive belts or the
grooves of the belt pulleys. If you do spill, clean
with alcohol. If the friction between the drive belt
and the pulley is not sufficient after you clean
with alcohol, replace the drive belt.
CAUTION:
other petroleum products to clean drive
belts.
24
Servicing dealers that
Do not use gasoline or
Grease nipple
A B
A C
Refer to
Lubrication
Lubricate the grease nipple on
A
the pivot axle with a grease gun.
Lubricate the grease nipple on
B
the wheel axle with a grease gun.
Lubricate the grease nipples on
C
each spindle with a grease gun.
Lubricate the grease nipple on
D
the cutting deck idler arm.
Always use good quality grease. Always use
recommended oil, refer to
29 .
To lubricate the front wheels
Note:
Use a grease gun when you lubricate the
front wheels.
•
Lubricate each set of front wheel mounts (A) and
bearings (B) 3-4 strokes.
A
A A
A B
A C
A C
D D
Technical data on page
B
2178 - 001 - 22.06.2023
