Idiomas disponibles
Idiomas disponibles
Operation
PUSH BAR
Press the push bar to open or close the door.
GARAGE DOOR OPENER LIGHTS
Press the LIGHT button to turn the garage door opener lights on or off. When the lights are turned
on they will stay on until the LIGHT button is pressed again, or until the garage door opener is
activated. Once the garage door opener is activated the lights will turn off after the specified period
of time (the factory setting is 4-1/2 minutes). The LIGHT button will not control the lights when the
door is in motion.
Light Feature
The lights will turn on when someone enters through the open garage door and the safety
reversing sensor infrared beam is broken. If using the garage door opener light as a work light,
turn the light on using the light button on the wall control or the light will turn off after a set
amount of time.
Program
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN
NOTE: The following steps are for standard accessories. If programming is unsuccessful, refer to your accessory or garage door opener manual for programming information.
1
Press and release the LEARN button on
the door control to enter Programming
Mode.
The garage door opener lights will flash (or two clicks will be heard) when the code has been programmed.
Repeat the steps above for programming additional remote controls or keyless entry devices.
2
Press and release the LEARN button
again, the LED will flash once.
Push Bar
LIGHT Button
3a
Press the button on the remote
control that you wish to operate
your garage door.
3
Command LED
LEARN Button
LOCK Button
3b
Enter a 4-digit personal
OR
identification number (PIN) of your
choice on the keyless entry keypad.
Then press the ENTER button.
?
?
?
?
PIN
