Idiomas disponibles
Idiomas disponibles
evaporator and pushed forward into the ice basket by the ice shovel. The ice tray will
automatically move back into position under the evaporator and start the next cycle.
10. The "
" indicator will light up when the ice basket is full and then the ice maker will
stop the ice-making cycle automatically. Gently remove the ice from the ice basket with
the ice scoop. About 5 seconds later, the ice maker will restart its ice making function
automatically.
11. The "
" indicator will light up when the water reservoir is lack of water and the ice-
making cycle will stop automatically. At that time, remove the ice basket and add water
to the water reservoir, and then press "
12. When you have got your desired amount of ice, stop the ice making cycle by pressing
the "
" key and unplug the unit from the wall outlet.
13. Open the top lid and transfer the ice to a freezer.
NOTE: The ice will last in the ice maker for up to a 18 hour period, depending on the
ambient temperature.
14. Allow the ice maker to wall up to room temperature.
15. Suggest replacing the water a week. Please empty the water reservoir if the ice maker
is not used for a long time.
Cleaning and Maintenance
To keep your ice tasting fresh and your ice maker looking great, we recommend cleaning
your ice maker at least once per week.
1. Stop the ice-making cycle by pressing the "
2. If residual water is found in the ice tray, gently push the ice tray back so that all water
drains into the water reservoir.
3. Move the appliance forward to a place 60mm away from the working table and open
the drain plug to drain out excess water (see Fig.1, Fig.2 and Fig.3).
4. Check and make sure the drain plug must be closed well. Fill the water reservoir with
clean water, press "
the pump will start to pump water and keep running for 6 minutes, and it will enter
into standby condition after running for 6 minutes, finally, open the drain plug and
empty the water.
5. Remove the ice basket.
6. Clean the ice maker interior with a soft cloth soaked with warm water and vinegar, then
rinse with clean water and then drain all the water.
7. Replace the drain plug well in position. Wash the ice basket and ice scoop in warm
soapy water. Rinse and dry.
8. Clean the exterior of the ice maker with a soft damp cloth. Use a mild dishwashing soap,
if necessary.
" until the '
' indicator flashes, then press the "
English - 8 -
" key again to restart the ice-making cycle.
" key. Wait five minutes and unplug.
" key,
