Idiomas disponibles
Idiomas disponibles
IDENTIFY USUAL TROUBLE OF WASHER
Identify usual trouble of washer
When the washer is in trouble, please contact local service office or the sales service department of our com-
pany and the customer should not dismantle the machine without permission.
If the washer can not work normally, or appear abnormity or alarms, please check and correct as follows.
List of faults and inspection
Faults
No water flows in
No washing
Abnormal draining
clothing spin
Nota: During the de spin process, if washing are piled at one side of the spin barrel, it will cause unbalance of
spin barrel resulting in striking. At this moment, the computer inside the washer will feel this unbalance phenom-
enon and will automatically correct it ( fill in water Washing ). However, if unbalance situation is not removed
after continuous three corrections, which means the computer auto-correction can not resolve the problem.
Then the user has to manually and evenly place the clothing inside the barrel to solve the problem
Inspection Items
If the power is off or the fuse is burned out.
If the water supply is cut off or the water pressure is too low.
If the inlet hose is properly connected and the water tap is opened.
If the filtering screen of inlet valve is blocked by dirt.
If the coil of inlet valve is damaged. (The slight electromagnetic
sound is normal phenomenon when the inlet valve is switched on)
If the "Start / Pause" button is pressed after the power switch is pressed.
If the power is off or the fuse is burned out.
If the power supply voltage is too low.
If the water amount reaches to the required water level.
(The washer will not work if the water amount does not reach the required
water level)
If it is set to "Delay" washing mode. (It will only start to work until the reservation
time reached)
If the water drain hose is placed very high.
If the end of water drain hose is sealed in pond.
If the internal rubber ring of drain valve is blocked by dirt.
If the door lid is closed.
If all clothing piled largely at one side of barrel or the abnormal is excessively
placed.
If the washer is not placed in stable condition or it is placed in inclination state.
(The ground is not flat).
If the motor belt is loosened.
40
AUTOMATIC WASHING MACHINE
TLA014580MD
