Electrex DC 164 Manual De Instrucciones página 16

LIFTIG welding
For DC 164 and DC 204 DC (See items in Fig. 3 A)
Item Letters Parameter
1 IP
Attention! The parameters below don't have a LED indicating their selection
Item Letters Parameter
NA TUP UP SLOPE
NA AOF ARC OFF
Pulsed LIFTIG welding – the welding current oscillates between a high and a low current value
allowing less thermal input in thinner plates and greater arc control.
Attention! The parameters below have no LED indicating their selection.
Item Letters Parameter
IB
NA
UTH
NA
Fre
NA
FREQUENCY
LIFTIG welding
Item Letters Parameter
1 IP
Attention! The parameters below have no LED indicating their selection.
Item Letters Parameter
NA TUP UP SLOPE
NA AOF ARC OFF
Pulsed LIFTIG welding – the welding current oscillates between a high and a low current value
allowing less thermal input in thinner plates and greater arc control.
Item Letters
IB
2
UTH
4
Fre
3
FREQUENCY
- Start welding.
I / I Adjust the main current value.
2 p
Rise time to main current.
Voltage regulation that allows the arc to be extinguished at an
adjustable distance without damaging the workpiece.
I
Adjust welding base current in percentage of main current.
b
WIDTH Adjust width of the peak current (main).
PULSE Adjust the pulse frequency.
For DC 224 (See items in Fig. 3 B)
I / I Adjust the main current value.
2 p
Rise time to main current
Voltage regulation that allows the arc to be extinguished at an
adjustable distance without damaging the workpiece.
Parameter
I
Adjust welding base current in percentage of main current.
b
WIDTH Adjust width of the peak current (main).
PULSE Adjust the pulse frequency.
Description
Description
Description
Description
Description
Description
16