Upholstery Cleaning - Castex PX-1500LP Manual De Operación Y De Piezas

FIG. 4.
3. Push floor tool forward over same path with trigger
released when returning for next stroke. Continue
this pull and push method with a slight overlap of
each stroke.
NOTE: For heavily soiled areas, repeat stroke or
change angle of stroke.
ATTENTION: Do not allow water or foam to enter
vacuum screen. Ball float will not stop foam
intake and vacuum motor damage will result (not
covered by warranty). If foam develops, remove
rear clear lid and pour 29.6 ml (1 oz.) of anti–foam
solution into recovery tank.
4. When finished cleaning, turn off switches and
drain recovery tank (See DRAINING RECOVERY
TANK).
5. Disconnect solution and vacuum hoses from
machine and neatly coil hoses for storing.
ATTENTION: Relieve water pressure from tool
before disconnecting hose. Squeeze trigger for
five seconds after turning off machine.

UPHOLSTERY CLEANING

This unit cleans most synthetic upholsery very well.
Extraction is not recommended for most cottons, silks
wools or natural fiber velvets. Check the cleaning
instructions sewn in the furniture by the manufacturer
for further instructions. Extra caution should be taken
with furniture that has been reupholstered. Any
material under the new upholstery may bleed and
discolor the new fabric.
1. Vacuum the upholstery before cleaning.
2. Test the fabric for color fastness. Pour a small
amount of cleaning solution on a white cloth. Hold
the damp portion of the cloth against an area of
upholstery which is hidden from view. Hold it there
for 60 seconds. If no color transfers to the cloth, it
should be safe to clean. However, always use
your best judgement.
PX-1500LP (07–99)
Home Find... Go To..
3. Attach the vacuum and solution hoses to the front
of the extractor and to the accessory tool.
4. Activate the vacuum and pump switches.
5. Hold tool 150–200 mm (6–8 inches) above fabric
and squeeze trigger to spray cleaning solution
(Figure 5.).
FIG. 5.
6. Place tool on fabric and slowly pull tool
backwards.
7. When finished cleaning, turn off switches and
drain recovery tank (See DRAINING RECOVERY
TANK).
ATTENTION: Relieve water pressure from tool
before disconnecting hose. Squeeze trigger for
five seconds after turning off machine.
8. After you have relieved pressure in the solution
hoses as directed above, disconnect the solution
and vacuum hoses.
WARNING: Flammable materials or reactive
metals can cause an explosion or fire. Do not pick
up.
OPERATION
5