Distance Measurement - GPO RANGEGUIDE 2800 8x50 Modo De Empleo

Distance measurement

The distance measurement mode is switched on by pressing
the measurement button once and remains in standby for
15 seconds.
Press the measurement button again
within 15
measurement. The distance is displayed.
To preserve battery life, the instrument
switches off automatically after 15 seconds
of inactivity.
Single measurement
With the RANGEGUIDE 2800 switched on, use the target
marker to aim at the object to be measured and press the
measurement button briefly. The direct distance is
displayed in the first line for 15 seconds. The device then
switches off automatically.
If the reflection from the object is not
sufficient for
following display appears:
16835
M
_ _ _ _ _ M/Y
Simply restart the measurement with a new
target.
seconds to start the
the measurement, the
48 48
Continuous measurement / scan mode
To switch on the scan mode, press and hold the
measurement button . As long as you keep the button
pressed, the device will continuously measure the distance
to the target object and display the respective distance to
different objects.
If you release the measurement button , the current
measured value will be displayed for a further 15 seconds as
for the single measurement. The device then automatically
switches to standby mode and then switches off after 15
seconds.
The direct distance, horizontal distance and angle display
are updated up to 4 times per second.
49 49
EN IT