ProFlow PF-SOF1-SIM Instrucciones De Instalación página 7

only for PF-SOF1,5
 Picture 1
1. On the brass valve seat:
make sure the O-ring in the riser insert is in the correct

position;
install the top distributor and fix it by means of the 2

stainless steel screws;
install the tank O-ring in the groove on the flange

around the threaded section.
2. Lubricate the threaded section of the pressure tank, the
top of the riser tube and the tank O-ring of the valve seat;
use a silicon-based lubricant.
3. Lower the valve seat straight down onto the riser tube,
until the riser tube is correctly inserted in the riser insert
inside the valve seat; then push it down firmly and screw
it onto the pressure tank.
4. Install the valve seat O-ring in the groove on the valve
seat.
5. Install the control valve onto the valve seat; mind the
alignment pin!
6. Bolt the control valve to the valve seat by means of the 4
stainless steel bolts; tighten firmly.
BRINE TANK ASSEMBLY (optional)
 Picture 2&3
1. Move the brine tank to the correct installation location;
position it on a flat and level surface. Make sure to leave
enough space for ease of service.
2. Insert the polytube into the brine line connection on the
control valve (); make sure to push the polytube in all
the way; tighten the nut.
3. Remove the lid from the brine tank.
4. Remove the lid from the brine well.
5. Make sure the correct elbow connection is installed on
the brine valve (⅜" for PF-SOF1 or ½" for PF-SOF1,5);
replace if necessary.
6. Run the polytube from the control valve through the hole
in the sidewall of the brine tank, to the inside of the brine
tank.
7. Only for PF-SOF1,5: insert the reinforcement tube in the
end of the ½" polytube.
8. Insert the polytube into the elbow connection on the
brine valve; make sure to push the polytube in all the way.
9. Only for PF-SOF1,5: tighten the nut.
10. Install the lid on the brine well.
11. Add water to the brine tank to a height of ±10 cm from
the bottom.
12. Add salt to the brine tank.
13. Install the lid on the brine tank.
ASSEMBLY
Page 7
EN - English