Makita SP6000 Manual De Instrucciones página 9

► 1. Locking lever
With the lock-off button depressed and the locking lever
turned, lower the handle so that the lock pin fits in the
groove formed by the locking lever and the depth guide
with scale plate. Make sure that the lock pin fits in the
groove.
Press the shaft lock fully so that the blade cannot
revolve and use the wrench to loosen the hex bolt coun-
terclockwise. Then remove the hex bolt, outer flange
and blade.
1
► 1. Hex wrench 2. Shaft lock
To install the blade, follow the removal procedure in
reverse. BE SURE TO TIGHTEN THE HEX BOLT
CLOCKWISE SECURELY.
4
3
2
1
► 1. Hex bolt 2. Outer flange 3. Saw blade 4. Inner
flange
When changing blade, make sure to also clean the
guard of accumulated sawdust as discussed in the
Maintenance section. Such efforts do not replace the
need to check guard operation before each use.
1
2
Dust bag (accessory)
CAUTION:
• Before use, make sure that the dust bag is
positioned so that it does not contact workpiece
during operation.
1
► 1. Dust port 2. Dust bag
To attach the dust bag, fit it onto the dust port. If the
dust bag becomes an obstacle to your work, turn the
dust port to change the dust bag position.
► 1. Fastener
When the dust bag is about half full, switch off and
unplug the tool. Remove the dust bag from the tool and
pull the bag's fastener out. Empty the dust bag by tap-
ping it lightly to remove as much of the dust as possible.
Connecting a vacuum cleaner
► 1. Vacuum cleaner 2. Dust port
9 ENGLISH
2
1
1
2