Idiomas disponibles
Idiomas disponibles
Digital Gauge
The digital gauge on the rapid inflator is multifunctional.
It serves as a pressure gauge, monitors the amount of
pressure being applied to the item being inflated.
To switch from PSI, BAR, or KPA.
1. With gauge ON, press the power button to select the
desired measuring unit (Fig. 9).
Fig. 9
Power button
To set pressure gauge for automatic shut off:
1. With gauge ON, press and hold down [ + ] or [ – ] buttons
to select desired shutoff pressure (Fig. 10).
NOTE: Numbers will flash while setting pressure.
Holding buttons down will make the pressure number
increase faster.
2. When desired setting has been selected, begin inflating.
Rapid inflator will shut off once setting is reached.
Fig. 10
Air pressure
(+) Button (–) Button
Air pressure
measurement
units
PSI
BAR
KPA
PSI
0.0
BAR
KPA
LED Light (Fig. 11)
The rapid inflator is equipped with a LED light above the
trigger switch to provide additional lighting for operation in
low light conditions. The LED light will turn on when the power
button [
] is pressed and will stay on for 60 seconds.
Fig. 11
LED light
Starting + Stopping
1. Slide the battery into the battery compartment until it
clicks to lock it into position (Fig. 12).
Fig. 12
2. To turn the rapid inflator ON, press the power button
[
] below the LCD display (Fig. 9).
NOTE: The digital gauge will automatically shut off when
not in use for 60 seconds or more.
3. With gauge ON, select the desired shutoff pressure by
pressing [ + ] or [ – ] buttons (Fig. 10). Once it is set,
wait a few seconds until the current tire pressure displays.
NOTE: Always check and follow the manufacturer's
recommended pressure, usually located on the door jamb
of your vehicle.
NOTE: Should the pump fail to reach the desired pressure
setting within 15 minutes, the pump will automatically shut off.
4. Place air chuck over valve stem and press down,
readout will appear on gauge (Fig. 10).
11
Battery
compartment
Battery
