Kaco blueplanet 25.0 NX3 M3 Guía Rápida página 7

Lifting and installing the device
Wall bracket mounted.

1 Lift the device using the grip recesses (see Fig. 3.2). Pay attention to the centre of gravity!
2 Fit the device onto the mounting bracket. Check both sides of the heat sink to ensure that it is securely in place.
3 Insert the screws provided (2x M5x14mm) into the lug of the mount and mount the device to prevent it from being lifted off
» Once the device is installed, proceed with the electrical installation
[ P / 2.5 Nm]
Fig. 6: Mounting the inverter to the wall bracket
Fig. 8.1: Securing the inverter
1.6 Making the electrical connection
NOTE
Select conductor cross-section, safety type and safety value in accordance with the following basic
conditions:
Country-specific installation standards; power rating of the device; cable length; type of cable installation;
local temperature
1.6.1 General view inverter from the bottom
Fig. 8.2: Connection site: Legend
A DC integrated isolator switch
B DC connector for PV generator
C COM1&2 – RJ45 socket for
KACO blueplanet 25.0 NX3 M2 KACO blueplanet 30.0 NX3 M2 KACO blueplanet 33.0 NX3 M2
D
E
RS485 connection F
Fig. 7: Check that the device is secure.
COM 3 – Connector for WiFi stick
AC connection socket
The position of the equipotential bonding
Page 7