Idiomas disponibles
Idiomas disponibles
Repeat the above procedure until the solvent or water emerging from the nozzle is
clear.
Turn of the machine and remove the plug.
CAUTION!
Never clean seals, diaphragm and nozzle or air holes of the spray gun with
metal objects.
The ventilation hose and diaphragm are only solvent-resistant to a limited
extent. Do not immerse in solvent, only wipe.
WARNING!
Never hold the spray gun rear part under water or immerse it into liquids.
Clean the housing only with a moistened cloth.
Clean the outside of the spray gun and container with a cloth soaked in solvent or
water.
Unscrew the union nut and remove the air cap and nozzle. Clean the air cap and nozzle
with a brush and solvent or water.
Fig. 8
Unlock button
16
Fig. 9
7, air lter
Maintenance
Change the air lter if it is soiled (Fig. 9, item 7).
be sucked in and interfere with the function of the machine.
Correction of Malfunctions
Problem
Cause
No coating
Nozzle clogged
material emerges
Feed tube clogged
from the nozzle
Material volume setting turned too far to the
left (-)
Feed tube loose
No pressure build-up in container
Coating material
Nozzle loose
drips
Nozzle worn
from the nozzle
Nozzle seal worn
Coating material assembly at air cap, nozzle or
needle
Atomisation too
Viscosity of coating material too high
coarse
Material volume too large
Material volume adjusting screw turned
too far to the right (+)
Nozzle contaminated
Air f lter heavily soiled
Too little pressure build-up in container
Spray jet pulsates
Coating material in container running out
Air lter heavily soiled
Coating material
Too much coating material applied.
causes "paint
tears"
Too much fog of
Distance to the object too large
coating material
Too much coating material applied
(Overspray)
Paint in the
Diaphragm soiled
ventilating hose
Diaphragm defective
Safety
Instructions
Remedy
Clean
Clean
Turn to the right (+)
Insert
Tighten container
Tighten
Change
Change
Clean
Thin
Turn material volume adjusting
screw to the left (-)
Clean
Change
Tighten container
Re ll
Change
Turn material volume adjusting
screw to the left (-)
Reduce distance Turn material
volume adjusting screw to the
left (-)
Clean the diaphragm
Replace the diaphragm
17
