Idiomas disponibles
Idiomas disponibles
• Be alert and turn machine off if children enter the area.
• For wheeled rotary machines, mow across the face of slopes, never up and down.
• Never allow children or people unfamiliar with these instructions to use the
lawnmower. Local regulations can restrict the age of the operator.
• WARNING—Petrol is highly flammable.
-store fuel in containers specifically designed for this purpose;
-refuel outdoors only and do not smoke while refueling;
-add fuel before starting the engine. Never remove the cap of the fuel tank or add
petrol while the engine is running or when the engine is hot;
-if petrol is spilled, do not attempt to start the engine but move the machine away
from the area of spillage and avoid creating any source of ignition until petrol
vapours have dissipated;
-replace all fuel tanks and container caps securely;
• Before using, always visually inspect to see that the blades, blade bolts and cutter
assembly are not worn or damaged. Replace worn or damaged blades and bolts in sets
to preserve balance.
• Never tamper with safety devices. Check their proper operation regularly.
• Keep machine free of grass, leaves, or other debris build-up. Clean oil or fuel spillage.
Allow machine to cool before storing.
• Exercise extreme caution when changing direction on slopes.
• Never attempt to make wheel height adjustments while the engine (motor) is running.
• Grass catcher components are subject to wear, damage, and deterioration, which could expose moving
parts or allow objects to be thrown. Frequently check components and replace with manufacturer's
recommended parts, when necessary.
• Mower blades are sharp and can cut. Wrap the blade(s) or wear gloves, and use extra caution when
servicing them.
• Do not change the engine governor setting or over speed the engine.
• Use extreme caution when reversing or pulling the lawnmower towards you.
• Stop the blade(s) if the lawnmower has to be tilted for transportation when crossing
surfaces other than grass, and when transporting the lawnmower to and from the area
to be mowed.
• Disengage all blades and drive clutches before starting the engine.
• Start the engine or switch on the motor carefully according to instructions and with feet
well away from the blade(s).
• Do not tilt the lawnmower when starting the engine or switching on the motor, except if
the lawnmower has to be tilted for starting. In this case, do not tilt it more than absolutely
necessary and lift only the part which is away from the operator.
• Do not start the engine when standing in front of the discharge chute.
• Never pick up or carry a lawnmower while the engine is running.
• Reduce the throttle setting during engine shut down and, if the engine is provided with a
shut-off valve, turn the fuel off at the conclusion of mowing.
• Go slow when using a trailing seat.
• ASSEMBLY / PRE-OPERATION
Read these instructions and this manual in its entirety before you attempt to assemble or operate your new
lawn mower.
IMPORTANT: This lawn mower is shipped WITHOUT OIL OR GASOLINE in the engine.
Your new lawn mower has been assembled and tested at the factory.
REMOVE LAWN MOWER FROM CARTON
Roll lawn mower out of carton and check carton thoroughly for additional loose parts.
INSTALLATTACHMENTS
Your lawn mower was shipped ready to be used as rear bag mower.
SET UP YOUR MOW ER
IMPORTANT: Unfold handle carefully so
as not to pinch or damage control cables.
1. Raise handles until lower handle section
locks into place in mowing position.
2. Remove protective padding, raise upper
handle section into place on lower
handle and tighten both handle knobs.
3. Remove handle padding holding operator
presence control bar to upper handle.
Push handle
Drive lever
Instruction for big wheel assembly
1. To get two wheels from package, and put inner wheel into outer one.
2. To get accessory part, and assemble wheels as figure shows.
3. Direct the central hole of the big wheel assembly against the central
axle of the drive bracket
4. Put washer into the hole of big wheel, and screw stellated handle nut
down. The other side of wheel should be assembled by same way.
The sensitivity of clutch
lies on tightness-scale of
nut.
Brake lever
Put button three times before
starting the engine
