Idiomas disponibles
Idiomas disponibles
Tractor
To clean the product
Do not use a garden hose or a pressure washer to
clean the surface except for the washout port. Keep
water out of the engine and transmission. Water in
the engine or transmission can decrease the life of
the product. Use compressed air or a leaf blower to
remove grass, leaves and litter.
•
Clean all unwanted material from the engine,
battery, seat and other parts of the product.
•
Clean contamination from the steering plate.
Contamination limits the movement of the clutch/
brake pedal shaft, causes the belt to loosen and
decreases forward movement.
CAUTION:
points and movable parts.
•
Keep the surfaces and wheels free of all
gasoline, oil, and so on.
•
Use automotive type wax to prevent damage to
the surfaces.
To use the deck washout port
The cutting deck has a deck washout port that is a
part of the cleaning system for the cutting deck.
WARNING:
with a broken or missing deck washout
port. There is a risk of thrown objects.
Replace a broken or missing deck
washout port immediately.
Note:
For the models with guards, the washout
port is installed on the left side guard in front of the
rear tire.
1. Park the product in a clear area on your lawn that
is near a water source with a garden hose.
CAUTION:
discharge chute of the product in the
direction of buildings or vehicles.
2. Make sure that the cutting deck is disengaged.
To engage and disengage the cutting
Refer to
deck on page 15 .
3. Turn the ignition key to the STOP position to stop
the engine.
4. Engage the parking brake.
5. Remove the grass catcher chute or the mulch
plug if it is installed.
20
Avoid all pinch
Do not use the product
Do not point the
6. Put the nozzle adapter onto the end of your
garden hose (A). Make sure that the garden hose
is fully connected to the nozzle adapter.
A
B
7. Pull back on the lock collar of the nozzle adapter
and push the nozzle adapter onto the deck
washout port (B).
8. Carefully pull on the garden hose to make sure
that it is fully connected.
9. Release the lock collar to lock the adapter on the
deck washout port.
10. Start the water supply.
11. Sit in the seat and start the engine.
CAUTION:
again to make sure that the area is
clear.
12. Move the throttle control to the fast position.
To use the throttle control on page 15 .
Refer to
13. Engage the cutting deck and let it operate until
the cutting deck is clean. Refer to
disengage the cutting deck on page 15 .
14. Disengage the cutting deck. Refer to
and disengage the cutting deck on page 15 .
15. Turn the ignition key to the STOP position to stop
the engine.
16. Stop the water supply.
17. Pull back the lock collar of the nozzle adapter
and disconnect the nozzle adapter from the deck
washout port.
18. Move the product to a dry area.
19. Engage the cutting deck and let it operate until
the cutting deck is dry.
To adjust the throttle control cable
The throttle control is set at the factory and
adjustment should not be necessary. If an
adjustment is necessary, see the Engine manual.
To adjust the choke control
The choke control is set at the factory and
adjustment should not be necessary. If an
adjustment is necessary, see the Engine manual.
Examine the area
To engage and
To engage
1963 - 002 - 13.10.2022
