Idiomas disponibles
Idiomas disponibles
■
Replace defective light bulbs with new ones
immediately. Before changing the light bulb,
make sure that the circuit to which the prod-
uct is connected is not live. To do so, remove
the fuse or switch off the circuit breaker in
the fuse box (position 0).
■
Only use lamps of the specified type (see
type plate and "Technical data").
■
Allow the LED light to cool down for at least
15 minutes before replacing a defective bulb.
■
Do not under any circumstances use the
product to store or hang up other objects.
■
Never use the connection cable to carry the
weight of the product.
■
WARNING!
If you notice unusual
oscillations, stop using the ceiling fan imme-
diately and consult qualified personnel.
■
Should doubts arise during assembly/use of
the product, consult a qualified electrician.
■
The replacement of safety suspension parts
must be carried out by the manufacturer, his
customer service representatives or suitably
qualified persons.
■
For your safety!
■
Install the ceiling fan in a location where it is
protected from moisture and dirt.
■
A ceiling height of at least 2.55 m is required
for safe operation. The fan blades must be
at least 2.3 m away from the floor and 0.6
m away from the nearest wall or item of
furniture. The ceiling to which the product is
mounted may slope by a maximum of 30 °.
■
Do not operate the ceiling fan if the ambient
air temperature is over 40 °C.
■
Unpack the ceiling fan carefully on a soft
surface to avoid damaging the surface of the
ceiling fan.
■
Do not lay the motor housing on its side,
as this could bend and damage the decor
housing.
■
Always be alert! Always pay attention to what
you are doing and always use common sense.
■
Do not install the product if you are having
difficulty concentrating or do not feel well.
■
Before use, familiarise yourself with all the
instructions and diagrams in these instructions,
as well as with the product itself.
Preparation
Tools and materials required
The specified tools and materials are not included.
The information and values specified are non-
binding and are only provided as a reference. The
nature of the material is determined by the specific
local conditions.
- Pencil/marking tool
- Voltage tester
- Screwdriver
- Power drill
- Drill bit
- Side cutters
- Ladder
- Pliers
Note: DO NOT use power tools to tighten the
screws. Excessive tightening can damage the
thread of the screws.
Prior to installation
■
Prior to installation, familiarise yourself with
all the instructions and diagrams in this manu-
al as well as with the ceiling fan itself.
■
Before installation, ensure that the circuit to
which the product will be connected is not live.
To do this, remove the fuse or switch off the
circuit breaker (0 setting) in the fuse box.
■
Prior to installation, make sure that the
installation site is suitable to bear the weight
of the product.
■
Use a voltage tester to verify that cables are
not live.
GB/IE/NI/CY/MT
9
