Idiomas disponibles
Idiomas disponibles
Do not use any insect spray in or on the tent.
Small leaks on the seams can be repaired with
a seam spray and impregnation spray can be
used for the tent skin.
m
CAUTION! DANGER OF POISONING
AND DAMAGE TO PROPERTY! Do not
light any fires within the product and keep it
away from sources of heat.
You should also familiarize yourself with the
local fire protection regulations (e.g. camping
site, tent pitch).
m
WARNING! DANGER OF
SUFFOCATION! If using gas or other
combustion appliances additional ventilation
will be required. If the inside of the tent is
not adequately ventilated, there is a risk of
suffocation.
Make sure that the vents on the side of the
inner tent are not covered at any time.
Do not leave children unattended in the tent.
The logo on the inner tent
access slot for USB cables (for LED lighting or
phone charging).
WARNING! Do not use high voltage
appliances or hot appliances in the
tent, as this may cause fire or electric
shock.
˜ Fire precautions
Camp safely. Follow these commonsense
rules:
Do not place hot appliances near the walls,
roof or curtains.
Always observe the safety instructions for these
appliances.
Never allow children to play near hot
appliances.
Keep exits clear. Do not block the exit with
objects.
Make sure you know the fire precaution
arrangements on the site.
10 GB/IE
indicates it is an
7 ]
[
˜ Tent assembly
Please ensure that the product is only
assembled by people with the appropriate
skills.
Note: The polyester material of the tent
consists of water-repellent material.
It is possible that during the first rainfall the tent
will not be completely watertight. However, the
threads of the tent will contract when exposed
to water so that after a short time the tent will
become watertight.
Erect the product in accordance with the
illustrations A to I.
Illustration A and B:
1. Place the outer tent
tunnels for the poles
upwards.
2. Run the two fiberglass poles
end forward into the two tunnel guides on the
outer tent one after another and slide them
through to the end.
3. Push the fiberglass pole
through the tunnel guide on the awning so that
it extends evenly on both sides of the tunnel
guide.
Illustration C and D:
4. Set the tent
up and fix the poles
[
1 ]
the metal pins of the floor fastenings.
Illustration E:
5. Fix one side of the tent in the ground with the
tent pegs
. Then take hold of the other end
5 ]
[
of the tent and pull it apart in such a way that
the tent is taut.
flat on the ground. The
1 ]
[
must be facing
2 ]
[
3 ]
[
with the plastic
2 ]
[
of the awning
[
3 ]
,
2 ]
[
3 ]
[
to
