UFESA CF Katmandu Manual De Instrucciones página 22

PRE-INSTALLATION INSTRUCTIONS
Before installing this product, read the package list in previous pages and ensure all
parts are present and display no defects. DO NOT attempt to install the product if any
part is missing or damaged. Read the safety information before installation or use.
Additional tools required for assembly:
• Cross-head Screwdriver
• Flat Head Screwdriver
• Adjustable Pliers or Wrench
• Step Ladder
• Wire Stripper
• Impact Drill (For Cement Floors)
• Electrical Tape
• Safety Glasses
Additional helpful tools:
AC/DC tester light, tape measure, wiring handbook, and wire cutters, hammer.
WARNING: NEVER bend the blade brackets/flanges during assembly or after installation.
DESCRIPTION
Unpack your fan and check the contents. Do not discard the carton. If replacement or re-
pair is ever necessary the fan should be returned in original packaging. Remove all parts
and hardware. Do not lay motor housing on its side: the decorative casting may shift.
Examine all parts. You should have the following:
1. Mounting bracket
2. Motor assembly
3. Body cover
4. Lamp shade
5. Fan blade brackets (3 pcs)
6. Middle cover
7. Controller kit
8. Sleeve anchors (for cement)
9. Mounting screws (for wood)
10. Fan blade screws (6 pcs)
11. Fan blades (3 pcs)
MOUNTING BRACKET INSTALLATION
1. Select the installation method according to the structure of the ceiling (as shown in
Figure 1 or 2), and use appropriate fasteners.
2. Install the mounting bracket on the building structure as shown in the figure. The fan
base mounting bracket must support a load of 25 kg.
3. If you want to hang the fan on a ceiling without joists, you may need a hanger support bar.
HANGING MOTOR ASSEMBLY
1. Use a Phillips screwdriver to remove the four screws on the mounting bracket (Figure 3).
2. Align the four holes on the motor assembly bracket with the four holes on the moun-
ting bracket, and then tighten the four screws in sequence.
22