ACTIVATION OF ESTETIKA MOTORIZZATA
ATTENTION
REMOTE CONTROL ONLY 15 CHANNELS
Before programming the remote control
select the channel (from 1 to 15) chosen
for the flyscreen. Channel 0 simultaneously
drives all flyscreens, but DOES NOT ALLOW
programming of any flyscreens.
LEFT MOTOR
To associate a remote control press -with a paper clip
or a thin screwdriver- the P1 button visible from the
appropriate slot in the head of the mosquito net until
the motor oscillates 1 time up and down and emits an
acoustic signal.
ROTATION DIRECTION
Verification of the rotation direction of the
motor
Verify the correct rotation direction of the motor
If the direction is not correct, push
simultaneously the buttons 1 and 2 until the
motor swings
Istruzioni di assemblaggio – Assembly instructions – Notice de montage – Montageanleitung – Manual de ensamblaje
1
PROCEED WITHIN A MAXIMUM OF 1.5 MINUTES
AFTER STARTING THE PROGRAMMING PROCEDURE.
Move the visible motor switch on the mosquito net
head to ON (to the right) to awaken the automation
from the "hibernation" mode.
4
Press 1 time WITH LONG PRESS the STOP button
of the remote control, the motor oscillates 2 times
up and down and emits 3 acoustic signals in sign of
association successfully.
7
UPPER STOPPER
Upper stopper calibration
Move the handle bar with buttons 1 and 2 up
to the desired point. Push simultaneously the
buttons STOP and 1 until the motor swings
twice and emits 3 acoustic signals, showing
the connection is correct.
2
MOTOR ON THE RIGHT
To associate a remote control press the P1 button
visible from the appropriate hole in the head of the
mosquito net, the motor oscillates 1 time up and down
and emits an acoustic signal.
5
8
LOWER STOPPER
Lower stopper calibration
Move the handle bar with buttons 1 and 2 up
to the desired point. Push simultaneously the
buttons STOP and 2 until the motor swings
twice and emits 3 acoustic signals, showing
the connection is correct.
3
6
9
∕ 45
