Idiomas disponibles
Idiomas disponibles
Care and Cleaning
Clean periodically with a soft cloth. Avoid abrasive cleaners,
steel wool, and harsh chemicals as these will dull the finish and
void your warranty.
Troubleshooting
PROBLEM
There are leaks underneath
the handle.
Water does not completely
shut off.
The faucet leaks around the
aerator.
There is an improper water
pattern.
POSSIBLE CAUSE
The bonnet has come loose or the O-ring
on the cartridge is dirty or twisted.
The rubber valve seat is dirty, stuck, or
broken.
The aerator is incorrectly fitted.
The aerator is dirty or small parts inside
the aerator are improperly installed.
CORRECTIVE ACTION
1. Move the handle to the OFF position. Unscrew the handle screw and
remove the handle.
2. Tighten the bonnet by turning it clockwise. Move the cartridge stem
to the on position. The leak should stop draining out from around the
cartridge stem.
3. Shut off the water supply. Remove the bonnet by turning it counterclock-
wise. Lift out the cartridge valve. Inspect the larger O-ring on the cartridge
bonnet and the smaller O-ring on the cartridge stem. Remove any debris
from the O-rings. If either O-ring is twisted, straighten it out. If either
O-ring is damaged, replace the cartridge by calling customer service.
4. Position the cartridge back into the faucet body. Make sure the ridges on
the two sides of the cartridge bonnet fit into the grooves on the two
sides of the faucet body. Tightly screw the bonnet onto the faucet body.
5. Re-install the handle.
1. Shut off the water supply to the faucet that leaks.
2. Remove the handle on the problem side. Loosen the bonnet by turning
it counterclockwise. Lift out the cartridge assembly.
3. Inspect the rubber valve seat in the faucet body. If there is debris or
brass scrap on the surface of the seat, remove it. If the rubber seat is
stuck tightly in the water inlet hole, push it gently with a fingertip so
that it moves up and down smoothly. The spring (smaller end up) must
be replaced underneath the valve seat. If the rubber valve seat is worn
out or broken, replace the cartridge by calling customer service.
4. Replace the cartridge in the faucet body. Make sure that the ridges on
the two sides of the cartridge bonnet fit into the grooves on the two
sides of the faucet body. Tightly screw the bonnet onto the faucet body.
5. Re-install the handle.
1. Unscrew the aerator by turning it clockwise. Inspect the black rubber
packing inside the aerator. The rubber packing should be flat.
2. Screw the aerator onto the spout end and tighten.
1. Remove the aerator from the spout end by turning it clockwise.
2. Gently flush the small parts inside the aerator to clear away any debris.
3. Re-install the small parts as shown in the exploded diagram. Metal
screens must be flat and plastic supporter must be straight.
4. Screw the aerator onto the spout end and tighten.
7
Please contact 1-855-HD-GLACIER for further assistance.
HOMEDEPOT.COM/GLACIERBAY
