Pip Table; Self-Diagnosis; Removing The Monitor Stand (All Models); Attaching The Monitor Stand - Interlogix UVM-2600 Manual De Usuario

PIP table

VGA HDMI DVI CAM1 CAM1
SUB
X
VGA
X
HDMI
DVI
 
CAM1
 
CAM2
 
S-
Video
X = Not supported
 = Supported

Self-diagnosis

If there is no image, the Self-Diagnosis screen
will be displayed. The self-diagnosis function
checks if the status of the monitor screen is
No Signal, Out of range or None support.
No Signal screen is displayed
when the D- Sub signal
connector is connected but the
status of the monitor is on DPMS
mode.
Out of Range screen is
displayed when the applied
frequency is under or over
normal range.
Normal range (Non-interlaced
mode only):
H: 30 to 80 kHz
V: 56 to 77 Hz
Check that the cable screen is
displayed when the analog
signal cable is disconnected.
Removing the monitor
stand (all models)
1. Turn off the monitor and unplug the
power cable.
2. Place a cushion or a soft cloth on the
floor and put the monitor on it with the
front of the monitor facing the floor.
User Manual
Main
Video
X
X  
 
 X
 X
X X

3. Detach the rear cover of the monitor
stand with a screwdriver.
4. Remove the six screws connecting the
S-
stand and monitor body.


X
X
Screws (x4)
Attaching the monitor
stand
Tighten the screws at the locations indicated
by arrows shown in the figures above. See
pictures below.
Monitor stand attached
here
The monitor's installation surface is
compatible with other types of VESA standard
stands.
VESA mount specifications:
Model
UVM-2600
UVM-3200
Face of monitor
stand arm
Specifications
VESA standard: 100 x
100 mm and 200 x 100 mm
(3.94 x 3.94 in. and 7.87 x
3.94 in.)
Screw thread: M4 screw
Length: 8.0 mm
VESA standard: 200 x
200 mm and 400 x 200 mm
(7.87 x 7.87 in. and 15.75 x
7.87 in.)
Screw thread: M5 screw
Length: 10.0 mm
9 EN