Idiomas disponibles
Idiomas disponibles
REMOVING SOCKETS
1. Always follow the procedure below to remove a socket. Pull out the socket from
the anvil of output drive directly. (see Fig. 3)
CAUTION
wrench on bag, work table, tool cabinet.....etc.
FORWARD / REVERSE LEVER
The tool is equipped with a forward/reverse lever (see Fig. 4A), which was designed to
change rotation of the output drive.
1. For forward rotation, turn the lever counter-clockwise to the "F" position.
2. For reverse rotation, turn the lever clockwise to the "R" position.
NOTE
Always check the direction of the rotation before use.
2. After continuous use, allow the ratchet wrench to sit idle for 2 minutes before
replacing the battery. The temperature of the motor, switch, etc., will rise if the
work is started again immediately after the battery has been changed, eventually
resulting in burned-out.
3. Place the point of the bolt in the socket. Keep the tool pointed straight at the bolt.
4. Apply forward pressure to the tool to prevent the socket from slipping off the bolt.
5. To start, turn ratchet wrench. Always check torque with a torque wrench. The
1English1
Always set lock button (4) to off position when installing and
removing socket or prevent the switch on when place the
Counterclockwise
A
(output drive pointed away from you)
OPERATION
Fig. 4
English
-8
Clockwise
