JBM 60047C Manual De Instrucciones página 8

OPERATION
Select the direction of rotation by using the di-
rection selector.
Caution: Only change the direction when the
tool is completely stopped.
Select the action mode by rotating the action
mode selector.
You can select three modes of operation:
Mode
Screwdriving
Drilling
Hammer-drilling
In the screwdriving mode you can select the
speed (0-20) by rotating the screwdriving tor-
que selector.
Caution: When you select the mode of opera-
tion, make sure that the icon points directly to
the arrow. Otherwise, you could break the tool..
To put the drill in the chuck, turn the sleeve
counter clock wise
Place the bit in the chuck.
Turn the sleeve clockwise to tighten the bit.
Install the battery on the tool.
To start the tool, press the trigger.
Tool speed is increased by increasing the pres-
sure on the trigger.
Icon
To select the maximum speed, put the speed
selector in position 2.
Caution: Never change the speed selector po-
sition while the tool is running.
· 8 ·
REF.60047C