Cardin Elettronica SSB Serie Manual Del Usuario página 23

6. Memorising the keyboard in a standard receiver or in an electronic programmer
To memorise the keyboard in a receiver at least one user code must have been memorised (along with the
functions you wish to activate).
With the receiver in the vicinity carry out the procedure using the "MEMO" key
1) Type a user code into the keyboard: the keyboard is ready to transmit (green LED lit).
2) Press and hold down the MEMO button on the receiver: the red LED in the receiver will flash slowly.
3) Activate the channel to be memorised (A, B, C, D): in the keypad.
4) Keep the MEMO button pressed down on the receiver, until the red LED on the receiver starts to flash
5) Activate the same channel on the receiver a second time (if the channel is different the memorisation
procedure will quit without memorising the keypad)
6) End of the memorising procedure: the red LED on the receiver remains lit for 2 seconds indicating that the
keyboard has been memorised correctly.
Note: You cannot memorise a keyboard that already exists in the receiver's memory: in this case, while you
are memorising the channel (point 3) the red LED on the receiver will stop flashing.
The programming procedure will only carry on after the MEMO button (in receiver) has been released.
If you don't press the channel a second time within 15 seconds the memorisation procedure will quit without
memorising the keyboard.
23