TREND RS/JIG Instrucciones Originales página 8

• Set depth of cut to 1.5mm maximum and router
speed. – (Fig. 10)
• Rout towards front of jig in small cuts.
– (Fig. 11a & Fig 11b)
Ensure the bottom plate of the router
carriage & ski assembly is about 15mm
above the component. Component can be
raised as required.
Maximum 1.5mm depth per pass.
Whenever clamps are used, ensure
they do not foul the router path and that
they are securely tightened.
To prevent damaging the jig make sure
the router plunge is fully released after
completing the cut.
ACCESSORIES
Please use only Trend original accessories.
MAINTENANCE
Please use only Trend original spare parts and
accessories.
The jig has been designed to operate over a long
period of time with a minimum of maintenance.
Continual satisfactory operation depends upon
proper tool care and regular cleaning.
Cleaning
• Regularly clean the jig with a soft cloth.
Lubrication
• Your jig requires no additional lubrication.
Storage
• After use store jig in its packaging or it can be
hung on a wall hook.
Spare Parts
• See website for details.
EN - RS/JIG
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
as waste. Packaging should be sorted for
environmental-friendly recycling.
The product and its accessories at the end of
their life should be sorted for environmental
friendly recycling.
WARRANTY
This unit carries a manufacturer's warranty in
accordance with the conditions on our website
www.trend-uk.com
- 8 -