Idiomas disponibles
Idiomas disponibles
Other Keys
Backlight
The meter display Is set with
backlight. Press the key for 2 seconds
to light. Press the key for 2 seconds
again to turn off the backlight.
HOLD data hold key
Press "HOLD" key. The meter
display will keep the last test
reading; and show" "symbol. Press
"HOLD" key again and the meter will
restore to normal measuring state.
RAN Manual/Automatic
Switch Key
1. In voltage and resistance
measurement position, clamp
meter is set to automatic
measuring range by default.
2. Press this key to switch to manual
measuring range.
3. In the manual measuring range
mode, click the key once to jump
to upper grade. If It Is at the top
grade, then It will jump to the
bottom grade. Hold this key for
2 seconds to switch back to
automatic measuring range.
4. MAX Maximum reading value
display.
340161747_MNL_IN_V01.indd 15
340161747_MNL_IN_V01.indd 15
EN Use
5. Press "MAX" key. The display will
show the maximum reading value
among measuring data.
6. Press the "MAX" key again.
The meter will revert to normal
measurement state NCV Non-
contact voltage detection switch
Used for non-contact voltage
detection.
Instructions
DC Voltage Measurement
1. Insert red probe to "INPUT" jack
and insert black probe to "COM"
jack.
2. Place function measuring range
switch to DC voltage measuring
range. Press "SEL" key, and
connect the probe to the power
source or load to be tested.
The polarity of the end connected
with red probe will be shown In
the display at the same time.
3. Read the measuring result from
display.
NOTE:
• If the range of voltage to be
tested Is not known In advance,
place function measuring switch
to the maximum range, then
gradually reduce to obtain the
correct range.
15
03-03-2022 17:31
03-03-2022 17:31
